- Webern
- Forum Member
Steve, I installed a soft synth called http://soniccharge.com/synplant I used Logic automation to automate a parameter on this soft synth.
When I followed the instructions in Logic 303 TNT2 #31 Igor's Automation Tip, Pan and Volume automation were affected, but the soft synth automation was not.
A couple questions:
1) Can all types of automation be manipulated as demonstrated in the video?
2) Is it possible when manipulating automation regions, to effect only one automation control and not the others? For example, could you re-size an automation region and only re-size the Panning automation while leaving the Volume automation unchanged?
When I followed the instructions in Logic 303 TNT2 #31 Igor's Automation Tip, Pan and Volume automation were affected, but the soft synth automation was not.
A couple questions:
1) Can all types of automation be manipulated as demonstrated in the video?
2) Is it possible when manipulating automation regions, to effect only one automation control and not the others? For example, could you re-size an automation region and only re-size the Panning automation while leaving the Volume automation unchanged?
Last Edited on Jan 29th 2012 @ 10:51 AM