Hi My default bar ruler display is 'bar and time'. In my project I've done a lot of edits using 'cut section' and 'insert silence'. The bar numbers in the bar ruler are spot on and start at 1, but the time now starts at 13.30 minutes instead of 0.00. How do I reset this so the time goes back to 0 at bar 1? Cheers Hamish

Hi Hamish, I've had this before and it drove me nuts until I found where to reset it. Open the project. Then go to File > Project Settings > Synchronization. And change the SMTPE back to 00:00:00:00:00 for bar 1. [url=http://www.macprovideo.com/forum/upload/upload/server/php/savedfiles/files/mpv_40534_14931_SMTPE.jpg] [img]http://www.macprovideo.com/forum/upload/upload/server/php/savedfiles/thumbnails/mpv_40534_14931_SMTPE.jpg[/img] [/url]

Genius! thanks Gary

Glad it worked.

the best part was it did it in real time, so as I dragged the numbers back to 00.00 I could see the bar ruler sorting itself out! Not the bigest issue but I'm really glad there was a fix - thanks again

thanks for info .... 2 years later ... saved me ... Peace B

THANK YOU!