So I've got 3 snares layered and sent to a buss with 100% wet reverb and Neutron gate so the reverb cuts off after a second or so. But every time I set the gate, it will work until I save the project and close out, then some time after that when I open the project again the snares will be completely dry. Then I go into Neutron gate and touch the open close bars and it kicks back on. Almost like I am nudging it awake. Sometimes I'll have to actually change the bars back to get the gate effect I want, and other times i just have to open the plugin and slightly move one of the open/close bars and it will pop back on. I want to just add the gate and then bounce the file in logic to prevent this from happening, but when I bounce the snares only the channel strip gets bounced -- not the buss strip. Is that how a bounce is supposed to work?